Just wondered if anyone has any suggestions as to what may be going on here?  Sometimes the loops work, sometimes it goes to the start of the loop rather than the end of the loop when GO is pressed.  It's causing a few problems

Hi Neil,

We've been doing some investigations and found that if you use fairly short loops, or if you press play to "loop exit" within  the last 8 seconds of a loop, then sometimes Myriad will play the loop through one more time before finishing the loop (because it's already buffered those "loops" ahead). We're putting in a new SmoothStream buffer mode of "short" to try and help alleviate this in the next release (v4.0.24).

In the meantime You could try using either longer loop sections, or if possible, can you try changing to "Immediately jump to the loop end" instead and see if that works more reliably?


------------
Peter Jarrett, Technical Director
Broadcast Radio Ltd.

Bill Bailey: No win, no fee, no basis in reality. Just a room above a minicab office in Acton and a steady stream of greedy simpletons whose delusion is only matched by their clumsiness